All calculators

Unit Converter

Convert the units you meet on drawings, specs and site: length, area, volume, mass, loads and stresses.

Step 1 · New to this? Start here

The basics

On site you meet a mix of units. Drawings are in millimetres, plots are sold in feet and acres, steel is quoted in tonnes, loads in kN and concrete strength in MPa. Mixing them up is one of the easiest ways to make an expensive mistake.

Every conversion works the same way: turn the value into a base unit (metres, m², kg and so on), then into the unit you want. The converter does both steps for you and shows the value in every unit at once.

mm and m
1 m = 1,000 mm. Kenyan drawings are dimensioned in mm.
Acre and hectare
1 acre = 4,047 m². 1 hectare = 10,000 m², about 2.47 acres.
kN
Kilonewton, the unit of force and load. 1 tonne of mass weighs about 9.81 kN.
MPa = N/mm²
The unit of concrete and steel strength. C25 concrete is 25 MPa.

Step 2

How to use this calculator

  1. 1Choose what you are converting: length, area, volume, mass, force or pressure.
  2. 2Type the value.
  3. 3Pick the unit you have under From, and the unit you want under To. Use the swap button to reverse them.
  4. 4Read the big result, or scroll the list to see the value in every unit.

Step 3 · Convert

Result
3.048 Metres (m)

Drawings in Kenya are dimensioned in millimetres. 1 m = 1,000 mm.

10 Feet (ft) in every unit

  • Millimetres (mm)3,048
  • Centimetres (cm)304.8
  • Metres (m)3.048
  • Kilometres (km)0.003048
  • Inches (in)120
  • Feet (ft)10
  • Yards (yd)3.333333
  • Miles (mi)0.001894

Step 4 · Check your understanding

Worked example

A client has a 50 x 100 ft plot and wants to know the area in m² and acres.

  1. 1. Area = 50 x 100 = 5,000 ft²
  2. 2. 1 ft² = 0.0929 m², so 5,000 x 0.0929 = 464.5 m²
  3. 3. 1 acre = 4,047 m², so 464.5 / 4,047 = 0.115 acres

A 50 x 100 plot is about 464.5 m², or 0.115 acres. Choose Area, type 5000, from ft² to m² to check.

Common mistakes to avoid

  • Converting the sides of a plot one by one and forgetting to multiply. Convert the area, not just the length.
  • Treating kg and kN as the same. Mass and force are different. Use 9.81.
  • Reading a drawing dimension of 3000 as 3000 m. It is 3000 mm, which is 3 m.