Lap and Anchorage Length
How long two bars must overlap, and how far a bar must run into concrete, to BS 8110, for high yield (Y) bars.
Step 1 · New to this? Start here
The basics
Steel bars come in 12 m lengths, and many members are longer than that or are cast in stages. Where one bar ends, the next bar must overlap it so the force can pass from one to the other through the concrete. That overlap is the lap length.
Anchorage length is similar: it is how far a bar must run into concrete, for example into a column or support, so that it cannot pull out before the steel itself yields.
BS 8110 gives both as a multiple of the bar diameter (d). Stronger concrete grips the bar better, so the multiple goes down as the grade goes up. Bars at the top of a deep pour or at corners grip less well, so their laps are made longer.
- 40d
- Forty times the bar diameter. For a Y12 bar, 40 × 12 = 480 mm.
- Tension lap
- A lap in a zone where the bars are pulled. This is the usual case in beams and slabs.
- Compression lap
- A lap where bars are squeezed, such as most column bars.
- fcu
- Characteristic cube strength. C25 means fcu = 25 N/mm².
Step 2
How to use this calculator
- 1Check the structural drawing first. If it states a lap length, use that.
- 2If it does not, pick the bar size and the concrete grade from the drawing.
- 3Choose where the lap is: normal, or at the top of a member or a corner, which needs longer laps.
- 4Read the tension lap. Use the compression lap only where the engineer confirms the bars are in compression.
Step 3 · Enter your numbers
Results
Estimates for learning and planning. Always confirm quantities with your engineer or quantity surveyor.
Step 4 · Check your understanding
Worked example
A Y12 bar in C25 concrete, lapped in a normal position.
- 1. BS 8110 Table 3.27, Y bars in C25: tension lap = 40d
- 2. Lap = 40 × 12 = 480 mm
- 3. If the same lap is at the top of a beam: 40 × 1.4 = 56d = 672 mm, rounded up to 675 mm
Lap the Y12 bars by 480 mm in a normal position, or 675 mm at the top of the beam.
Common mistakes to avoid
- Using one lap for every bar size. The lap grows with the diameter, so a Y16 lap is longer than a Y12 lap.
- Lapping all bars at the same point. Laps should be staggered so they do not all fall in one section.
- Placing laps where the bending is highest, such as the middle of a beam's bottom bars. Follow the detail on the drawing.
How it's calculated
- Values from BS 8110-1 Table 3.27 for high yield deformed bars (Y bars, fy = 460 MPa), as multiples of bar diameter
- C25 / C30 / C35 / C40+: tension anchorage and lap 40d / 37d / 34d / 32d
- Compression anchorage 32d / 29d / 27d / 25d
- Compression lap = 1.25 × compression anchorage, rounded up: 40d / 37d / 34d / 32d
- Tension lap × 1.4 at the top of a member, at corners or with small cover; × 2.0 when both apply
- Results rounded up to the nearest 5 mm. Always follow the lap stated on your structural drawings first